How do i take apart the lower frame of my KSC G17

[Hectic]

any help would be awesome i think i can take it apart with the 2 pins on the grip but im not sure if itll be easy to put back after i change the hammer spring and mag relese
Also ifd a gun doc in toronto area wants to let me know how much to change these parts i have pm me thanks

[Kerbosa]

hey. The trigger mechanism is a little tricky to put back in, just be patient and pay close attention when removing it as to how it goes together as it goes back in the same way.
PM me if you want more info.

A takedown schematic can be found here.
http://www.kicbbgun.com.tw/menu/ksc-g17s.jpg

[CDN_Stalker]

The hammer assembly is the bugger to put back together, not the trigger assembly. To get it all out, remove the pin at the rear of the grip, and the larger one above the trigger. Press down on the brass flat spring that holds the takedown latch in place, the work the latch out of the frame (pay attention to how it comes out, two square dents face rearward), then undo the screw holding the frame reinforcement liner in place. Everything should come out now.

And youi'll have to cut about 1mm from the spring that works the mag release if you are installing a metal catch. Is just a straight peice of spring steel, dislodge it and use pliers to pull it out, cut it, put it back in. Pretty easy that part.

[Hectic]

Thanks.
is there any special lube i should use and on what parts

[CDN_Stalker]

Can put some grease on working parts, some on the slide rails, and then put a bit of oil into the hammer assembly just to make sure there is coverage everywhere in case you missed something. Aside from that..........

[Hectic]

Any Grease?