**SOLVED** KJW Glock 23 Part ??

[Olisharpeye]

Recently, during the middle of a transaction (my) Glock 23 failed during its second game. The gun wouldn't cycle, after pulling the trigger the force would be enough to push the slide back a bit, but than the magazine would slowly vent out.

So realizing something in the hammer assembly wasn't correct, I stripped it completely to find a part that is broken. Unfortunately I am stuck with an explosive diagram that I cannot read. Looking at the KJW Explosive diagram for the 23, I noticed when I stripped the hammer assembly, that I was missing two parts from the diagram, and the one broken part wasn't even on it. So I checked out the Tokyo Marui glock 23 diagram and found the part that was broken, and refering to the parts I did have and TM Explosive Diagram, it looked like I had all the parts.

DAMAGED PART:


TOKYO MARUI GLOCK 23 EXPLOSIVE DIAGRAM


**I need part G17-23**

KJW GLOCK 23 EXPLOSIVE DIAGRAM


The parts I couldn't find when I disassembled is 48 and 53A

I've checked a few Canadian retailers, but no luck. I've contact my seller and KJW. They said it could be months before parts become available.

So I was wondering if somebody has come across the same issues and knows someone to contact. As well if anyone knows where to find a guide to put the hammer assembly back together,

Thank-you in advance.

[cellulose]

Here you go:

http://www.airsoftparts.ca/store2/in...roducts_id=923

[Mitchell12]

My glock is running well but just out of curiosity does anyone know what other parts are compatible with the 23 from the TM 17?

[Olisharpeye]

Originally Posted by aBseNtceLL

Here you go:

http://www.airsoftparts.ca/store2/index.php?main_page=product_info&products_id=923

Thank you so much!

[cetane]

I have that piece in my g23. So it is a direct swap. Kinda sucks putting a $30 part that small to make a $200 pistol work again.

[cellulose]

But on the bright side you have a reinforced part and your piece is that much more awesome.

[cetane]

Originally Posted by aBseNtceLL

But on the bright side you have a reinforced part and your piece is that much more awesome.

Ya true. In the USA you can get a complete lower kjw g23/32 replacement piece with magazine for $50 that part does hurt a bit. Stuff up here too expensive.

[Olisharpeye]

Gun Fixed. Ran into a problem where the trigger wouldn't remain seated after being cocked, the spring fell off the closing latch. But miraculously after trying to get the slide off many times, it locked. So I fixed that. The gun now shoots without leakage.

WOOH!

I've learned how to disassemble the trigger assembly of the Glock 23, man what a bitch to put back together lol.

Thank-you aBseNtceLL and airsoftparts.ca!

[jeb104]

how do u take it out