gas leaking from magazine pins?

[Neurotrauma]

I have a TM m9 mag, with hollow roll pins and I've tried lubing the fill nozzle, removing it, spraying inside, wrapping the fill nozzle in teflon tape.

I have been unable to remove the pins yet to get inside it because I cant find a pin punch that will work with the hollow roll pins. The leak is coming directly out of the pins and apparantly nowhere else. Not sure what to do even if I get it open, most people dont leak from pins because theirs arent hollow... any help would be appreciated.

[Styrak]

You mag is most likely leaking from the seal in the baseplate. You have to take it off and inspect the o-ring, and most likely replace it.

[Neurotrauma]

thanks, if only I could figure out a way to get the pins out, ive tried hitting em pretty good with a hammer and proper sized allen key and I just cant seem to get em out. At this point im looking to buy an actual roll pin punch but im skeptical if even then I can get them out...

[CDN_Stalker]

They will come out, and after do my blue automotive gasket sealer trick (thread available on here how to do it).