Hi-capa gripreplacement - QUESTION

[Reaver_RRTS]

Hey guys,

I just purchased myself a little something-something (TM 5.1 :P ) and was looking into personalizing it. I have several items picked out, but one I'd love is a new grip. The one I'm trying to find I can't seem to locate... And I'm HOPING it still exists.

It's a grip that can utilize 1911 panels. I think Tanio Koba used to make it, but the ones I see now by them don't state if they actually use 1911 panels.

Anyone know?

Thanks.

Edit: The two I saw were made by Guarder and the other by Tanio Koba (KJW?) but they looked identical and wasn't sure if either could take 1911 grip panels. I don't believe they can considering the difference in thickness between the two grips since the Hi Capa is a double stack and 1911 is single. With that in mind, it stands to reason what I'm looking for doesn't exist, does it?

[shootersaber]

In my experience, the guarder grip same with tanio koba, but the thick of this grip is not pretty good fit. This trigger ring is bigger than original, it will be jammed. I think you place the original trigger grip is better.

[Sequential]

Most aftermarket grips are garbage, they fit slanted and end up getting gaps between the safety lever and lower frame.
If you want something nice look for the PRIME stuff.

[Reaver_RRTS]

Thanks guys. On a side note, anyone hear from ILLusion recently?