Quote:
Originally Posted by RacingManiac
so you've changed your slide/barrel again since the we saw it at the match last time? because it wasn't shooting at the time....
|
No.... I didn't change anything except the mag.
At the time, I was still using an unmodified valve knocker, which as you know, sticks a bit in to the mag wells and requires you to rack the slide before inserting a mag, otherwise it'll get blocked.
Problem is, I have some of my mags tuned with high flow valves that allow you to customize the height of the strike face. Some of them I have tuned so close to the edge, that it just did not work in this gun. When I tested it that day, it was with one of those mags and I did not think to try a different mag - I just assumed the valve knocker was too long.
Out of the 5 mags I have, 3 of them work fine, so the choice is to either re-tune the valve heights, or just take down the valve knocker length, which is the better of the two options.
Quote:
Originally Posted by RacingManiac
so it locks back too huh?
|
Yep, blows back very hard and crisp through almost the entire mag.