Airsoft Canada - View Single Post - Revolver Cycling problem ? look at the cylinder lock.

Jimski · February 23rd, 2009, 08:15

heya all.

PC7 didn't cure properly for some reason ( or I didn't wait long enough ) and the part broke again.
I ended up using polyurethane glue, this thing is stronger than it looks and fills all the space you can't get with soldering or putty.

The part actually works, its elevation needs to be very precisely adjusted to release the cylinder and block it right afterwards.This part suffers a very pic torsion to the left, I suspect it's going to break again. As murdock said it would need to be made of steel.

The good news is that it apparently restored a proper cycling, the barrel coaxiality seeming not so hard to obtain after all (all the gas comes out front)
coming next:shooting test

February 23rd, 2009, 08:15	#7
Jimski Trader rating Join Date: Jun 2005 Location: Montreal	heya all. PC7 didn't cure properly for some reason ( or I didn't wait long enough ) and the part broke again. I ended up using polyurethane glue, this thing is stronger than it looks and fills all the space you can't get with soldering or putty. The part actually works, its elevation needs to be very precisely adjusted to release the cylinder and block it right afterwards.This part suffers a very pic torsion to the left, I suspect it's going to break again. As murdock said it would need to be made of steel. The good news is that it apparently restored a proper cycling, the barrel coaxiality seeming not so hard to obtain after all (all the gas comes out front) coming next:shooting test __________________ Last edited by Jimski; February 23rd, 2009 at 08:18..