Quote:
|
Originally Posted by mcguyver
Did you guys try a rubber cement. I used to use it years ago to glue the spider and surround to speaker frames during re-coning of speakers. It would bond rubber and fabric to steel or aluminum and would hold up for years with all the motion a speaker cone goes through. You used to be able to buy it at Crappy Tire, but this was years ago and if I remember it was made by Lepage's. Sorry to get off-topic here.
|
It's because the inside of the rubber pad is waffle like. So there is not enough surface erea to stick on. If hold well if you don't touch it or don't force it, but the minute you go prone and crawl around a bit, you end up loosing it again.
That's why I put the zipties on. Tape would do fine too, but I wanted to preserve the look as much as possible.
Contac glue in spray is awsome for gluing spiders. But leave a mess to clean up after!