|
Fixed! Thanks guys! Bought some of the gasket goo that Jugglez suggested, used it to almost fix the leak in my Omega 93R (at least I was able to shoot it, still need to deal with the release valve) but I got my new KSC Glock gaskets today, covered in oil and stuck it in. Didn't bother with the goo this time, had a bugger of a time getting both pins in. What I did? Tapered one end of each pin, so it'd press the end cap down when entering the holes, and found best is to put a pin in one side, tap it partially in, then put the other pin in on the opposite side, then tap one flush, then the other. Filled the mag, loaded some BBs in, found the few few shots wouldn't even cycle the slide at all, put some oil in all the parts, rubbed the release valve gasket with it, loaded more, propane again, knocked off every shot without a burp. Another bunch of BBs in it, all fired and cycles just fine.
Thanks for all your help, glad I posted this, and it'll make a damn fine resource for future people to successfully fix their mags.
|