Airsoft Canada - View Single Post - G&G PDW99 (P90)

The Phoenix Reborn · September 15th, 2017, 22:26

I may consider that as well. I'm finding my 9.6v Nunchuck to be a much tighter fit than I'd like.

On another note though, I do have some good news! After some research, I was finally able to find an aftermarket part that works for my PDW99. It's a metal rail-mount base by First Factory / Laylax. This thing just BARELY fit the PDW99 upper-receiver, but works right out of the box. No physical alternations were required, but I did have to fiddle with the tightness of the screws a bit as I've found that when screwed in too snugly, the magazine has issues fitting lol... But hey, I'm just glad that I can finally fit my mock-holographic onto this baby =) Check it out!

September 15th, 2017, 22:26	#10
The Phoenix Reborn Trader rating Join Date: Apr 2009 Location: Ontario	I may consider that as well. I'm finding my 9.6v Nunchuck to be a much tighter fit than I'd like. On another note though, I do have some good news! After some research, I was finally able to find an aftermarket part that works for my PDW99. It's a metal rail-mount base by First Factory / Laylax. This thing just BARELY fit the PDW99 upper-receiver, but works right out of the box. No physical alternations were required, but I did have to fiddle with the tightness of the screws a bit as I've found that when screwed in too snugly, the magazine has issues fitting lol... But hey, I'm just glad that I can finally fit my mock-holographic onto this baby =) Check it out!