Airsoft Canada - View Single Post - Any one with experiance with flat-hops?

lurkingknight · August 21st, 2013, 10:12

dude, BBs push through fine with a naked barrel and rubber, they don't push through fine when it's all packed into the hopup unit, that's that. After adjusting they all work fine though and they all have great accuracy.

Maybe I just have bad luck and all the barrels I've done are in between the kit patch sizes. A couple required less adjustment than the other 2. It's the nub size that seems to push it down at 0 hop. I've asked HS5 about it and he said it was luck of the draw, if it still shoots straight after needing that much rework then it's still installed right, it just takes longer.

August 21st, 2013, 10:12	#20
lurkingknight "bb bukakke" KING! Trader rating Join Date: Jul 2011 Location: Ottawa	dude, BBs push through fine with a naked barrel and rubber, they don't push through fine when it's all packed into the hopup unit, that's that. After adjusting they all work fine though and they all have great accuracy. Maybe I just have bad luck and all the barrels I've done are in between the kit patch sizes. A couple required less adjustment than the other 2. It's the nub size that seems to push it down at 0 hop. I've asked HS5 about it and he said it was luck of the draw, if it still shoots straight after needing that much rework then it's still installed right, it just takes longer. __________________ I futz with V2s, V3s and V6s. I could be wrong... but probably, most likely not, as far as I know.