|
Take an Allen key and dab a bit of JB weld on it then shove it in the worn out set screw. Let it cure using whatever you have to hold it up straight. Tape and cardboard work, just be creative. Remove when dry.
Just make sure to not let too much ooze out. Clean up any excess.
I recommend JB weld over crazy/super glue because it will fill up the space in the stripped set screw. I mean you can try it but in my experience crazy glue might not hold up to the rotational torque applied.
Also crazy glue might drip down into the threads screwing you over for good. Pun intended.
|