Quote:
Originally Posted by Sepulcrum
Where are you located? maybe a gun doc can try and get her on there for you.
|
a fine idea, and it is possible to get the gun to a well respected 'gun doc' but seems an awful lot of fuss for what appears to be a simple issue.
I'm based in the UK and have regular contact with the team at Zero-one airsoft
as well as other helpful contacts etc. As point of interest, in the pictures on page 1 in the 1st picture "KA-RAS-02" there is a small metal ring,
this was the message i got from Wolf Armouries:
"Hi there,
This ris is a free float ris that require washer rings to be fitted
correctly (should have been provided with the RIS.)
The key to fitting this RIS is brute strength i am afraid.
You would need to screw on the ris with the washers and make sure the
top ris of the ris unit ALMOST meets with the top ris of the body.
About 1 cm till it lines up.. then its a case of using whatever tools
in hand to force it till it lines up. After that it should be rock
solid.
hope this helps
Wolf"
The kit I have (the G&P kit) had no washers or rings, only what appears to be the main component parts of the Free-float hand guard.
Failing any help that may be offered here, I guess its off to the shop.