Thats looking hot Crunch! I'm still waiting for my 552, probably get some VN mags.

What products do I need to eliminate the barrel wobble?

Barrel wobble in a 416?! :shock:

I have no barrel wobble on mine. But knowing how parts on JG guns tend to be loose out of the box, I'd suggest you remove the RIS and see if the barrel is tightly attached to the body. I'd suspect that the nut is probably loose. I had to tighten pretty much ever nut, bolt and screw (except the barrel) on both my JG guns when I got them, as they were all loose.

I know .... it's unheard of. ;¡

just take off the RIS and tighten the ring

You might need some spacers though, if you tighten the nut too much, your screw for the RIS will chafe along the nut and loosen it again.

Electrical tape at the perfect place and everything should be okay. ;)

I can't get my RIS off. Here are same pics. I took all the screws out seen here. 4 in total. Sorry bout the quality, I took them with my PS3 Cam.

Removal of the front RIS shouldn't require you to remove the rail on the upper receiver. You have to remove the rail from the front barrel. Not sure exactly what's involved, as I haven't done it myself.

I already had it torn down for the ms100sp swap. I'm tryin to get this cocksucker off......AAARGH!

I GOT IT OFF!!!!!!!! You gotta get a little nasty with her.

lol are you serious, all you do is screw off the bolt beneath the RIS using an allen wrench and it slides right off.

That shouldn't require removing the upper receiver rail either though. Not sure why you went that route.

I'm just learning about the intricacies of the AEG. I took it RIGHT down and studied it well. I'm a welder/fabricator and very good at detailed construction / de-construction.


And the RIS was quite tight.

I got the wobble fixed too. Thanks alot guys.

Long live the 416